Signal integrity

Probe's SI analyses: impedance, crosstalk, length matching, EMC nets and net timing — what they show and what material they require.

View as Markdown (for AI/KB) Whole knowledge base (llms.txt)

Signal integrity is about the signal arriving the way it should. Probe collects several SI angles, each pinned at the nets it concerns.

Impedance

The impedance check compares the traces’ controlled impedance against what the interface requires, from the stackup and geometry.

Crosstalk

The crosstalk panel raises nets positioned so they can disturb each other — where coupling between traces risks becoming a problem.

Length matching

Length matching reviews groups of nets that must hold the same electrical length (e.g. a bus or a differential pair). Matching groups can also be imported.

EMC nets and timing

EMC-relevant nets can be marked and followed, and net timing can be described where timing matters.

Material

These checks build on physical geometry (stackup, trace lengths) and require a layout. Requirements that build on a connector standard are taken from the standard packs.


Related: stackup and copper.

Probe is E-Sharp’s design-review engine. A check without enough material abstains rather than passes.

Book a demo of Probe

Show us your board — we review it and go through the findings together.

Prefer to email? info@esharp.se