# Signal integrity

> Probe's SI analyses: impedance, crosstalk, length matching, EMC nets and net timing — what they show and what material they require.

_Source: E-Sharp (esharp.se) · Probe guide_


Signal integrity is about the signal arriving the way it should. Probe collects several SI angles, each pinned at the nets it concerns.

## Impedance

The impedance check compares the traces' controlled impedance against what the interface requires, from the stackup and geometry.

## Crosstalk

The crosstalk panel raises nets positioned so they can disturb each other — where coupling between traces risks becoming a problem.

## Length matching

Length matching reviews groups of nets that must hold the same electrical length (e.g. a bus or a differential pair). Matching groups can also be imported.

## EMC nets and timing

EMC-relevant nets can be marked and followed, and net timing can be described where timing matters.

## Material

These checks build on physical geometry (stackup, trace lengths) and require a layout. Requirements that build on a connector standard are taken from the [standard packs](/en/probe/support/customer-standards-and-standard-packs).

---

Related: [stackup and copper](/en/probe/support/stackup-and-copper).

*Probe is E-Sharp's design-review engine. A check without enough material abstains rather than passes.*
