3D model and schematic cross-probing

See the board in 3D from an uploaded STEP model, and cross-probe between the schematic (intent) and the layout (as-built).

View as Markdown (for AI/KB) Whole knowledge base (llms.txt)

Two views help you read the design the way a human does: the 3D model and cross-probing against the schematic.

The 3D model

A 3D model (from an uploaded STEP) lets you see the board as it’s built — heights, mechanical fit, where things sit. It complements the layer view when a question is physical rather than electrical.

Schematic cross-probing

Probe reads the schematic as intent (via vision, sheet by sheet), while the netlist is the as-built truth. Cross-probing lets you jump between a part in the schematic and the same part in the layout — so “what did the designer mean” and “what was built” can be set against each other.

Why both

The netlist says what is connected; the schematic says what was intended. A finding often arises in the gap between them — and that’s why Probe holds both, rather than trusting one.


Related: the viewer — a tour and what Probe finds.

Probe is E-Sharp’s design-review engine. The schematic is read as intent, the netlist as as-built.

Book a demo of Probe

Show us your board — we review it and go through the findings together.

Prefer to email? info@esharp.se