View as Markdown (for AI/KB) Whole knowledge base (llms.txt)
A connector often carries a standardised pinout, but the netlist doesn’t say which standard. So Probe asks which connector family a placement follows — and the answer unlocks checks that otherwise can’t run.
Why Probe asks which connector it is
The netlist knows what is connected, but not which standard the connector should follow. When you (or your assistant) state the family, Probe can compare the actual connectivity against the standard’s pinout and raise deviations.
The family vocabulary
Families come from a closed vocabulary — a fixed library of known connector families, not free text. That keeps answers comparable across boards. Some answers close the question outright (the pinout is then unambiguously determined); others need a variant or side to complete them.
Standards with variant and side
For families that exist in several variants or orientations, you also state which — e.g. FMC, M.2, CompactPCI Serial, PXIe or VME exist in forms where variant and position decide the pinout. Saying “it’s an M.2” isn’t enough if keying and side change what the pins mean.
Part level or placement level
You can declare the family at part level (this article is always this family) or at placement level (this specific connector on this specific board). Placement level is right when the same physical connector is used differently on different boards.
Private families from your own specification
If you have an internal connector standard that isn’t in the public vocabulary, a private family can be defined from your own specification, so your boards can be checked against it the same way.
What it gives you
With the family set, Probe can run the pinout checks — it catches, for example, when a placement’s connectivity deviates from the standard’s pinout, or when a candidate connector hasn’t been referenced against a standard at all. As always: the deviation is pinned at the connector and carries its source.
Related: what Probe finds and interconnect review between boards (see Interconnect and the seam).
Probe is E-Sharp’s design-review engine. Probe doesn’t reason on its own — the AI in your own tool does the reasoning and you make the technical call.