conf – konfigurera kanal

Visar och ändrar kanalegenskaper (Alias, Direction, Unit, Enabled m.fl.) med kommandot conf.

Originaldokumentationen är på engelska. Visa som Markdown (för AI/KB)

Description

The conf command configures channel properties. It allows you to view and modify specific channel settings including Alias, Direction, ChannelType, Description, Unit, GroupName, DeviceName, and Enabled.

Syntax

conf --channel <channel_name> [options]

Required Options

Option Short Description
--channel -c The channel name to configure

Optional Options

Option Short Description
--parameter -p The parameter to set (Alias, Direction, ChannelType, Description, Unit, GroupName, DeviceName, Enabled)
--value -v The value to assign to the parameter

Examples

conf --channel "VOLTAGE_SENSOR"
conf -c "ADC_CH0" -p "Enabled" -v "true"
conf -c "GPIO_PIN" -p "Direction" -v "IN"
conf -c "VOLTAGE_SENSOR" -p "Alias" -v "MainPowerRail"

Output Format

Property Listing

Available Properties:
Alias                                    = MainPowerRail
NetName                                  = ADC_MODULE.CH0
Enabled                                  = True
Direction                                = IN
ChannelType                              = Analog
Description                              = Voltage measurement channel
Unit                                     = V
GroupName                                = PowerMonitoring
DeviceName                               = ADC_MODULE

Supported Parameters

Parameter Type Description
Alias String Short display name for the channel
Description String Descriptive text about the channel
Unit String Measurement unit (e.g., “V”, “A”, “°C”)
GroupName String Logical grouping name
DeviceName String Associated device name
Enabled Boolean Enable/disable state (true or false)
Direction Enum DirectionTypes (e.g., IN, OUT, INOUT)
ChannelType Enum ChannelTypes (e.g., Analog, Digital)

NetName is the full hierarchical name — displayed but read-only.

Best Practices

  1. List before setting: check available properties first with conf -c <channel>
  2. Verify changes: use get to confirm changes took effect
  3. Test incrementally: change one parameter at a time

Notes

  • Requires an active connection (use init first)
  • Changes take effect immediately via the API
  • Values are validated by the API layer

Error Handling

  • Channel not found: Verify channel name with list
  • Unknown parameter: Valid parameters are Alias, Direction, ChannelType, Description, Unit, GroupName, DeviceName, Enabled
  • Type mismatch: Value doesn’t match parameter type (e.g., Enabled requires “true” or “false”)

Boka en demo av Probe

Visa oss ditt kort — vi granskar det och går igenom fynden tillsammans.

Föredrar du att mejla? info@esharp.se