Insights

News, guides, application notes & articles

What we learn and what's happening with us — on test, design review, quality and catching faults early.

Case

Review of CERN's DI/OT Zynq UltraScale+ System Board

An independent, published review of a 14-layer FPGA carrier board — 67 findings, every one cited. The kind of thing ERC and DRC don't see.

9 min · Case
Design review

What a review finds that DRC misses

ERC and DRC prove a board is legal, not that it's right. Four functional errors that pass every rule check — and why a review is the step that catches them.

6 min · Article
Design review

Two ways to set an address, and both of them fitted

A pair of zero-ohm links lets you strap an address pin high or low. This board had both fitted on two pins — a dead short the single-net DRC check could never see.

4 min · Story
Design review

The formula was right. The number wasn't in the datasheet.

A 1.8 V rail on an AMS1117: the schematic's own arithmetic gives 1.799 V, but it uses an adjust-pin current that isn't in the datasheet. The real rail could sit anywhere from 1.72 V to 2.11 V.

4 min · Story
Design review

Twelve volts exactly

The feedback divider computes to 12.000 V and the margin looks comfortable. With 5 % resistors the rail can sit 776 mV below the power-good trip — and the BOM never says which resistors are fitted.

4 min · Story
Probe Interconnect

Two boards, both correct, and five volts on a Raspberry Pi

Each board passed review on its own. Mated, the module's 5 V rail lands on a 3.3 V Raspberry Pi header — a fault that exists only in the connection between them.

4 min · Story
Design review

One letter that inverts the fail-safe

Every symbol, footprint and pin was correct. The part number was one character off — and that character holds the I²C bus low exactly when the system tries to start.

4 min · Story
Design review

AI for design review: make it prove it

The danger of AI in board review isn't that it's wrong, but that you can't see when. Ground every answer in the board, and refuse the ones it can't prove.

8 min · Article
Design review

A design review checklist

Every experienced designer works to a checklist — memory is no method. But a checklist is a prompt for a review, not a record of one.

8 min · Guide
ODB++

ODB++ or Gerber for review

Gerber is an excellent manufacturing format and a poor review format. The question is which format answers what you're actually asking.

7 min · Application note
Design review

Review a board without a CAD licence

A review rarely fails on engineering skill, but on what the reviewer is allowed to do with the board. Looking is solved — asking is what's missing.

6 min · Article
Partnership

E-Sharp and Axis sign a five-year test-equipment agreement

E-Sharp will deliver more than 200 test systems to Axis Communications on the Accordion platform, under a five-year agreement spanning development, manufacturing and support.

2 min · News

Book a demo of Probe

Show us your board — we review it and go through the findings together.

Prefer to email? info@esharp.se