← Customer cases

Customer case · A leading global silicon design and verification provider

Turnkey NPI test for advanced data-centre systems

Every PCBA production test plus thermal verification for new, complex FPGA systems — supporting factories worldwide, with faster product introduction, higher reliability and full traceability.

Functional testData centreMultiple sites

2025-10-01 · 4 min read

E-Sharp functional-test fixture

A leading global provider of silicon design and verification systems engaged E-Sharp to design and deliver turnkey test solutions for its FPGA-based prototyping systems, as part of its New Product Introduction (NPI) process. The customer is not named here.

The challenge

Each prototyping system can hold up to a dozen FPGAs and tens of thousands of signals. A faulty board found after assembly can hold up the entire system, so the customer needed faults caught at the board level, before assembly — across factories in more than one country, with results that could be audited afterwards.

The approach

E-Sharp delivered the test stations end to end. Test specifications were written jointly with the customer. We wrote the initialisation and programming scripts, including multi-stage FPGA sequences, and the device drivers, including for the programmable power supplies. Test sequencing ran in NI TestStand. Custom test boards connected each device under test to the data-acquisition hardware, built around the second-generation Accordion Agent.

Two fixtures carried the mechanical side: Harmonix and Octave. Octave used a flip-jig mechanism and custom plugs able to handle thousands of contacts. Every result was logged to the customer’s manufacturing execution system (MES), so each board’s test record lived where the rest of production data did.

The result

The customer got faster, more repeatable testing, with faults detected earlier in the build and full MES traceability for every board. Operators handled the stations with less friction, and the same test approach could be rolled out across sites. We have not published throughput figures; the gains are in earlier detection and traceability rather than a single headline number.

When this fits

This is the right engagement for complex, high-signal-count systems where a late-stage fault is expensive and testing has to be consistent across factories. It is heavier than a single functional-test fixture — it only pays off when the product volume and complexity justify a turnkey, MES-integrated line.

See how we'd approach your product

Tell us what you're building and where it's stuck. We'll say honestly whether we're the right partner — and what a first step looks like.

Book a demo of Probe

Show us your board — we review it and go through the findings together.

Prefer to email? info@esharp.se