Module ESH10000534

PoE M.2

Controlled PoE supply for test — up to 90 W per port with detailed telemetry.

  • IEEE 802.3af/at/bt — full bt support, Class 8 / Type 4, up to 90 W
  • One four-pair port (internally channels 1–2), input voltage 42–57 V
  • Real-time current, voltage and power measurement per channel and total
  • Min/max current tracking for inrush analysis
  • 2 RGB status LEDs (polarity, input-voltage status)
Price on request
Description

ESH10000534 is an IEEE 802.3bt-compliant PoE source (PSE) in M.2 form factor. It provides a four-pair port supplying up to 90 W (Class 8 / Type 4) to a connected device (PD), with PoE negotiation, classification and protection via a dedicated PSE controller, real-time telemetry and visual status indication. Intended for PCBA test systems, production fixtures and PoE verification.

Use cases
PoE compliance and margin testing.
Power and inrush characterisation during NPI.
Production fixtures that require deterministic PoE behaviour.
System-level verification of high-power IEEE 802.3bt devices.
Technical information

Specifications, connections & manual

All technical material on the page — expand a section, or download the whole datasheet as a PDF.

Specifications

Parameter Value Notes
Module type PoE PSE module
Form factor M.2
PoE standards IEEE 802.3af / at / bt Full bt support
Maximum output power 90 W Class 8, Type 4 (QP90W)
Port configuration Single port, 4-pair Internally channels 1–2
Input voltage range 42–57 V
Current measurement 2 × 0–3 A Per-pair group
Power telemetry Per-channel and total
Visual indicators 2 × RGB LEDs POLARITY, VIN STATUS
PSE controller TPS23881

Manual

Hardware

Requires an external PoE supply (42–57 V), Ethernet magnetics and connector in the carrier system, and adequate thermal management near 90 W. PoE initialisation fails below 42 V; power delivery is inhibited until detection and classification succeed. LED diagnostics indicate input-voltage validity and PoE state/fault.

Software

All functionality is exposed via named channels {ModuleIndex}.ESH10000534.{ChannelName} — e.g. 0.ESH10000534.PowerStatusRegister.PG1.

Typical bring-up: set operating mode Auto → select power allocation (e.g. QP90W) → enable auto-class if precise negotiation is needed → enable detection, disconnect detection and power → verify PG1/PG2 and telemetry.

Telemetry includes per-channel and total current/power, min/max tracking for inrush (clear with TELEMETRY.CLEAR_PEAKS), and input-voltage monitoring. Faults (overcurrent, start-up timeout, thermal shutdown, supply under/over-voltage, PD disconnect) are exposed via the TPS23881 registers; clearing behaviour depends on the operating mode (Auto, SemiAuto, Manual).


Pinout

Pin Name Description
1 PWR Isolated PoE power (+56 V)
2 GND Isolated PoE ground
Related

Application notes, cases & news

Insights tagged for this product.

The right Accordion for your bench?

Tell us what you're testing and we'll find the right configuration — or say honestly if a standard setup is enough.

Book a demo of Probe

Show us your board — we review it and go through the findings together.

Prefer to email? info@esharp.se