# Stackup and copper

> Layer stack, reference plane, creepage and copper geometry in Probe — what the viewer shows and what's checked.

_Source: E-Sharp (esharp.se) · Probe guide_


The stackup part is about the board's physical build-up: the layer stack, the reference plane and the copper. It's the material for both signal integrity and power.

## The layer stack

Stackup shows the layer order — copper, dielectric, plane — as the ODB++ describes it. It's used to reason about impedance and return paths.

## Reference plane

For a signal layer, the nearest reference plane matters. Probe can point out the reference plane and raise when a signal lacks a good one (a return path that doesn't hold).

## Creepage

Creepage requirements describe the necessary distances across the surface between conductors at different potentials. Probe can hold requirements and raise where the geometry isn't enough.

## Copper geometry

The copper geometry (widths, areas, connections) sits behind the current analyses — see [power and PDN](/en/probe/support/power-and-pdn). Pure manufacturing geometry (DFM/clearance) is deliberately left to the CAM tools; Probe owns the functional side.

---

Related: [signal integrity](/en/probe/support/signal-integrity) and [the viewer — a tour](/en/probe/support/the-viewer-a-tour).

*Probe is E-Sharp's design-review engine. Clearance and manufacturing geometry sit with the CAM tools by design.*
